the wheel turns through equal angles.

if a wheel turns with constant angular speed then…

counterclockwise about an axis that is perpendicular to the page.

if the angular velocity vector of a spinning body points out of the page then, when viewed from above the page, the body is spinning

the body is slowing down

the angular velocity vector of a spinning body points out of the page. if the angular acceleration vector points into the page then

vertically upward

a car travels north at constant velocity. it goes over a piece of mud, which sticks to the tire. The initial acceleration of the mud, as it leaves the ground is

increases in magnitude and becomes more nearly radial

a wheel starts from rest and spins with a constant angular acceleration. as time goes on the acceleration vector for a point on the rim

speed of rotation

the rotational inertia of a wheel about its axle does not depend upon its

the one made from the more dense material

two uniform circular disks having the same mass and the same thickness are made from different materials. the disk with the smaller rotational inertia is

less

a uniform solid cylinder made of lead has the same mass and the same length as a uniform solid cylinder made of wood. the rotational inertia of the lead cylinder compared to the wooden one is…

drill holes near the axis and put the material near the rim

to increase the rotational inertia of a solid disk about its axis without changing its mass

applying the force at the rim, tangent to the rim

a force with a given magnitude is to be applied to a wheel. the torque can be maximized by

applied tangentially at the rim

a disk is free to rotate on a fixed axis. a force of given magnitude F, in the plane of the disk is to be applied. Of the following alternatives the greatest angular acceleration is obtained if the force is

pulls on both blocks, but exerts a greater force on the heavier block

a block is attached to each end of a rope that passes over a pulley suspended from the ceiling. the blocks do not have the same mass. if the rope does not slip on the pulley, then at any instant after the blocks start moving, the rope

the same

a disk starts from rest and rotates about a fixed axis, subject to a constant net torque. the work done by the torque during the second revolution is _____ as the work done during the first revolution